Battery; Switching On/Off - Rovary Rv2000P Bedienungsanleitung

Battery

The CO2 monitor can be charged by connecting the
USB cable when the device is ON.
When should the monitor be charged?
Empty battery: The top red light is on continuously,
which means it's important to charge the monitor within
20 minutes to prevent damage to the battery.
Charge: Flashing red light is visible.
Fully charged: The green light is on continuously.
Charging time is approximately 2.5 hours (charges for an additional 30 minutes after
the light changes from red to green). The battery operating time is about 5-9 hours.

Switching on/off

Push the pin on the back of the CO2 monitor to
activate the device.
To switch off the CO2 monitor completely, you must
press the pin so that it comes out.
Tip: Turn off the device if it is not going to be used for more than 1 week.
11