Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Normal startup procedure
Forward Only Mode:
Turn on the transmitter, move the
throttle stick in the bottom position.
When the motor emits "Beep----Beep", means
self-test is finished, the ESC is ready to work.
Forward and Reverse Mode:
Turn on the transmitter, move the
throttle stick in the neutral position.
When the motor emits "Beep----Beep", means
self-test is finished, the ESC is ready to work.
Programming items(the option written in bold font is the default setting)
1.
Brake Type: OFF/Soft/Mid/Hard
Timing: Auto/Low/Mid/High(5°/15°/25°)
2.
Motor Rotation: CW/CCW
3.
SR function: ON/OFF
4.
The synchronous rectification function makes ESC with higher driving efficiency and more energy-sa-
ving.
Battery cells: Auto/2S/3S/4S
5.
6.
Low Voltage Cutoff Threshold: OFF/NIMH50%/NIMH60%/3.0V/3.2V/3.4V/3.6V
For example: using 3 lithium batteries and setting 3.0V as the low voltage cutoff value, then the low
voltage protection threshold is: 3*3.0 = 9.0V
Low Voltage Cutoff Type: Reduce Power/Cut Off Power
7.
Reduced power: When the voltage drops to the set low-voltage protection threshold, the ESC will
reduce power to 70%. Cut Off power: When the voltage drops to the set low-voltage protection thres-
hold, the ESC will cut off the power immediately.
Acceleration: Normal/Soft
8.
Pichler Modellbau GmbH | Lauterbachstraße 19 | 84307 Eggenfelden
mail@pichler.de | 08721/508266-0
Connect the battery pack to the ESC and
wait for about 2 seconds.
The motor will beep several sounds, sounds
time presents the amount of battery cells.
Connect the battery pack to the ESC and
wait for about 2 seconds.
The motor will beep several sounds, sounds
time presents the amount of battery cells.
Werbung
