Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Wires Connection:
The speed controller can be connected to the motor by soldering directly or with high quality connectors. Always use new
connectors, which should be soldered carefully to the cables and insulated with heat shrink tube. The maximum length of
the battery pack wires shall be within 6 inches.
• Solder controller to the motor wires.
• Solder appropriate connectors to the battery wires.
• Insulate all solder connectors with heat shrink tubes.
• Plug the" JR" connector into the receiver throttle channel.
• Controller Red and Black wires connects to battery pack Red and Black wires respectively.
Throttle calibration
(Important: Please make the throttle calibration for the first time using ESC!)
Turn on the transmitter, move the
throttle stick in the top position.
The motor will beep several sounds, sounds
time presents the amount of battery cells.
When the motor emits "Beep----Beep",
means the ESC is ready to work.
Connect the battery pack to the ESC and
wait for about 2 seconds.
The motor will beep for twice, then move the
throttle stick to the bottom position in 3 seconds.
Werbung
