Securing The Refrigerator; Put On The Door Panel - Dometic Rml9336 Montageanleitung

Installing the refrigerator
5.7

Securing the refrigerator

!
CAUTION!
Only drill through the receptacles provided, otherwise foamed
components, including cables, can be damaged.
I
NOTE
Attach the side walls or the attached strips so that the screws are tight,
even when under increased loads (while driving).
Proceed as follows (fig. g, page 6):
➤ Move the refrigerator into its final location.
➤ Fasten the four screws (1) through the four plastic washers in the sides of the
refrigerator, and further into the wall.
➤ Put the caps (2) onto the screw heads.
5.8

Put on the door panel

A
NOTICE! Beware of damage
Only ever lay the refrigerator on its side and never on its back. Otherwise
the unit may be damaged.
The door panel has the following dimensions (fig. h, page 7).
Proceed as follows (fig. i, page 7):
➤ Remove the door trim carefully. It is only stuck on and held by small hooks (A).
➤ Slide the new panel into the opening (B).
➤ Replace the door trim (B).
✓ The door trim is secure once it clicks into place.
If you have laid the refrigerator on its side to insert the panel:
➤ Wait a few minutes before you switch on the refrigerator.
16
RML9336
EN