Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Problem and alarm code
Malfunction of the wash
pump or the drain pump.
The display shows i51 - i59
or i5A - i5F.
The temperature of the wa‐
ter inside the appliance is
too high or malfunction of
the temperature sensor oc‐
curred.
The display shows i61 or
i69.
Technical malfunction of the
appliance.
The display shows iC0 or
iC3.
The level of water inside the
appliance is too high.
The display shows iF1.
Network unit error.
The display shows iC4 Net‐
work Interface Error or iC5
Network Interface Error.
The appliance stops and
starts more times during op‐
eration.
The programme lasts too
long.
The displayed programme
duration is different than the
duration in the consumption
values table.
The remaining time in the
display increases and skips
nearly to the end of the pro‐
gramme duration.
Small leak from the appli‐
ance door.
Possible cause and solution
•
Switch the appliance off and on.
•
Make sure that the temperature of the inlet water does
not exceed 60°C.
•
Switch the appliance off and on.
•
Switch the appliance off and on.
•
Switch the appliance off and on.
•
Make sure that the filters are clean.
•
Make sure that the outlet hose is installed at the right
height above the floor. Refer to the installation instruc‐
tions.
•
Contact an Authorised Service Centre.
•
It is normal. It provides optimal cleaning results and en‐
ergy savings.
•
If the delay start option is set, cancel the delay setting or
wait for the end of the countdown.
•
Activating options often increases the programme dura‐
tion.
•
The pressure and the temperature of the water, the var‐
iations of the mains supply, the options, the quantity of
dishes and the degree of soil can change the pro‐
gramme duration.
•
This is not a defect. The appliance is working correctly.
•
The appliance is not levelled. Loosen or tighten the ad‐
justable feet (if applicable).
•
The appliance door is not centred on the tub. Adjust the
rear foot (if applicable).
ENGLISH
29
Werbung
