Werbung
Verfügbare Sprachen
Verfügbare Sprachen
16
www.aeg.com
6.7 TimeBeam
TimeBeam displays the following
information on the floor below the
appliance door:
• The programme duration when the
programme begins.
• 0:00 and CLEAN when the
programme is completed.
• DELAY and the countdown duration
when the delay start begins.
7. WIRELESS CONNECTION
You can connect your dishwasher to the
home wireless network and then link it to
your mobile devices in My AEG Kitchen
app. This functionality allows you to
remotely control and monitor your
dishwasher.
My AEG Kitchen app is available for
download from the app store on your
mobile device. You can scan the QR
code from the rating plate to be
redirected to the app (see chapter
"Product description").
The app is compatible with iOS and
Android operating systems. Check the
compatible versions of the operating
systems in the app store.
Wi-Fi module parameters
Wi-Fi module NIUS-SA
Frequency
Protocol
Max Power
Encryption
2.412 - 2.472 GHz
IEEE 802.11 b-g-n
<20 dBm
WPA, WPA2
• An alarm code when the appliance
has a malfunction.
When AirDry opens the
door, TimeBeam is off. To
check the remaining time of
the running programme, look
at the control panel display.
6.8 PNC number
If you contact an Authorised Service
Centre, you need to provide the product
number code (PNC number) of your
appliance.
The number can be found on the rating
plate on the appliance door. You can
also check the number on the display.
Select PNC number from the setting list
to check the number.
7.1 How to connect the
dishwasher to the network
and to the app
To connect your dishwasher, you need:
• Wireless network with the Internet
connection.
• Mobile device connected to the
wireless network.
1. Launch My AEG Kitchen app on your
mobile device and follow the
instructions in the app. When
prompted in the app, activate the
wireless connection in the
dishwasher.
2. To activate the wireless connection,
follow one of the two methods:
• Press and hold simultaneously
and
for 2 seconds.
• Enter setting mode, select the
setting WiFi and change its
values to ON.
The display shows Wi-Fi is starting up
and then Wi-Fi is ready.
3. When prompted, enter the home
network credentials in My AEG
Kitchen app.
Werbung
