Dometic EA24B Montage- Und Bedienungsanleitung Seite 23

EA24B, EA24D
EA24D only
1. Fix the drawers with duct tape when moving the device.
2. Attach the anti-tip brackets on the floor (fig. 0, page 8).
3. Position the device.
6.6 Connecting the device to the power supply
A
NOTICE! Damage hazard
• Do not modify or damage the plug.
• Do not plug the device in an socket that can be turned off by a switch
or pull chain.
• To avoid voltage drops and loss of performance do not use adapters,
extension cords, or power strips.
• Ensure that an residual current circuit breaker is installed to the
power supply. Seek advice from a trained electrician.
• Observe the input voltage (see chapter "Technical data" on
page 34).
I
NOTE
Let the device stand upright for 24 hours before connecting it to the
power supply.
➤ Plug the device into a AC socket.
6.7 Adjusting the feet
I
NOTE
The bottom of the device must be horizontal.
➤ Ensure the device is level by adjusting the feet (fig. a, page 8).
6.8 Changing the door hinge
The hinge of the door can be changed so that it opens to the left instead of to the
right.
➤ Change the door hinge (fig. b, page 9 to fig. d, page 11).
EN
Installation
23