WOLFF TUBRO-STRIPPER Originalbetriebsanleitung Seite 17

f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work to be
performed.
Use of the power tool for operations diff erent from
those intended could result in a hazardous situation.
5) Service
a) Have your power tool serviced by a qualifi ed
repair person using only identical replacement
parts.
This will ensure that the safety of the power tool is
maintained.
2.2 Machine-specifi c Safety Warnings
Read all safety warnings, instructions,
illustrations and specifi cations provided
with this power tool.
Failure to follow all instructions listed below may
result in electric shock, fi re and/or serious injury.
► Do not use damaged tools. Before each use
inspect the wheels for chips and cracks. If the
power tool is dropped, inspect for damage or
install an undamaged tool.
► Wear personal protective equipment. Depending
on the application, use a face shield, safety
goggles or safety glasses. As appropriate, wear
a dust mask, hearing protection, gloves.
The eye protection must be capable of stopping
fl ying debris generated by various operations. The
dust mask or respirator must be capable of fi ltrating
particles generated by your operation. Prolonged
exposure to high intensity noise may cause hearing
loss.
► Keep bystanders a safe distance away from the
work area. Anyone entering the work area must
wear personal protective equipment.
Fragments of workpieces or of a broken accessory
may fl y away and cause injury beyond immediate
area of operation.
All manuals and user guides at all-guides.com
► Hold the power tool only by the insulated
► Position the cord clear of the moving accessory.
► Regularly clean the power tool's air fi ns.
► Do not operate the power tool near fl ammable
► Do not use accessories that require liquid
Additional safety warnings
► Never use the machine with a damaged cable.
Noise/vibration information
gripping surfaces when performing an operation
where the cutting tool may come into contact
with hidden wiring or its own cord.
Contact with a "live" wire will also make exposed
metal parts of the power tool "live" and shock
the operator.
If you lose control of the power tool, the cord may
be cut or snagged.
The motor's fan will draw the dust inside the
housing and excessive accumulation of powdered
metal may cause electrical hazards.
materials.
Sparks could ignite these materials.
coolants.
Using water or other liquid coolants may result in
electrocution or shock.
Wear safety goggles.
Do not touch the damaged cable and pull the
mains plug when the cable is damaged while
working.
Damaged cables increase the risk of an electric
shock.
Wear hearing protection.
Measurements determined in accordance with
EN 60745
EN
17