cecotec CONGA TRITON 4000 ULTRACLEAN Bedienungsanleitung Seite 28

ENGLISH
4. OPERATION
Note:
If connection is made to a potable water system, the system shall be protected against
backflow.
This high-pressure cleaner is designated with a rated input current. The intended use of this
product covers the cleaning of vehicles, buildings, terraces, facades and garden equipment
using clean water and biodegradable chemical detergents. Likewise, the product can be used
to clean paving slabs or rain gutters.
This product may not be used to clean clothing, shoes and other textiles.
Be aware of kick-back: Hold with both hands.
Safety devices
Power switch
The appliance switch prevents unintentional operation of the appliance.
Trigger gun lock
This lock locks the lever of the trigger gun and prevents the inadvertent start of the
appliance.
Pressure switch
If the lever on the trigger gun is released, the pressure switch turns off the pump and the
high-pressure jet is stopped. If the lever is pulled, the pump is turned on again.
Motor protection switch
The motor protection switch turns off the device if the power consumption is high.
Personal protective equipment
Wear protective clothing and safety goggles to protect against splash back containing water
or dirt.
During the use of high-pressure cleaners aerosols can develop. Inhaling aerosols can cause
health damage.
Operation with soap
Note: Follow the instructions of the used detergent's manufacturer.
Remove the cap of the clean soap bottle.
Gently pull the soap bottle out of its storage position.
Fill the tank with detergent designed specifically for use with pressure washers.
Push the detergent bottle with the opening pointing downwards into the connection for the
hose clean detergent.
54
CONGA TRITON 4000 ULTRACLEAN
Recommended cleaning method
Spray the detergent sparingly on the dry surface and allow it to react, but not to dry.
Spray off loosened dirt with the high-pressure hose.
After operation with soap
Remove the hose clean detergent bottle from the intake and close it with the lid.
For storage, put the detergent bottle into the retainer with the cap pointing up.
Vacuum cleaner operation
Make sure that the switch is set to the off position. Plug it into a power supply.
Adjust the air flow as indicating below:
Open the air flow block, suck power will come down.
Fig. 12.
Turn on the switch "VAC(II)". The device is ready to vacuum.
Interrupting operation
Release the lever of the trigger gun.
Lock the lever of the trigger gun.
Place the trigger gun with the spray lance into the parking position.
During long breaks (more than 5 minutes), also turn the appliance off using the power switch.
Finish operation
Release the lever of the trigger gun.
Turn off the appliance switch.
Disconnect the device from the power supply.
Note: Only separate the high-pressure hose from the trigger gun or the device when there is
no pressure in the system.
Turn off the tap.
Press the lever of the trigger gun to release any remaining pressure in the system.
Release the lever of the trigger gun.
Lock the lever of the trigger gun.
Note: When disconnecting the supply or high-pressure hose, warm water may leak from the
connection.
Disconnect the device from the power supply.
Transporting it by hand
Switch the product off and disconnect it from the water and power supply.
Pull out the transport handle until it audibly snaps into place. Attach transportation guards, if
applicable.
Pull the appliance by its transport handle.
ENGLISH
55
CONGA TRITON 4000 ULTRACLEAN