Werbung
INSTALLING THE APPLIANCE
I)
Remove door and frame
a. Open door to 90 degrees
b. Remove safety plate with allen key on top hinge
c. Lift door so bottom hinge pin is out of the holding hinge plate
d. Tilt base away from stove and lower door
e. Door should now be released
f. Place door in a safe place
II) Remove frame from stove
a. Once door is removed;
b. Loosen/unscrew the four allen keys and frame will come off:
III) Remove Brick set
a. See manual below
IV) Remove bar from flue collar
a. Loosen bolts holding flue collar
b. Remove flue collar taking care not to loose bolts and nuts.
V) Fit collar to stainless steel flue (we recommend a 500 mm
of 1 mm stainless steel if possible)
VI) Fill any void at the back and sides with a 6;1 vermiculite to
cement mix or any other good quality non-combustible
insulation material. It is important that the back and
sides of the stove are well insulated.
VII) Connect the stove to the flue
a. Pull stove collar to top of stove from inside the appliance
b. Align bolt locations and re-bolt the spigot (and flue) to stove
c. Tighten bolts and secure
VIII) Finish around stove
IX) Re-fit frame
a. If installed into a newly plastered room or stove surround
please take care not to leave the painted frame and door fitted,
as the extremes of moisture as the plaster dries can cause
corrosion to the paintwork.
b. Before re-fitting door and frame, store door and frame in a dry
and well ventilated place while allowing the plaster to dry
X) Re-fit door
XI) Re-fit brick as shown in the instructions at page 24
'Vermiculite fire brick installation sequence' .
WESTFIRE · WF32
11 | 36
UK
Werbung
