Werbung
Verfügbare Sprachen
Verfügbare Sprachen
-
The device should have a 220/230V 50/60Hz power supply.
-
The device's power supply must be directly connected to the main
supply after the circuit breaker without any intermediate switch.
-
The device's power cable must be connected to the main supply via a
connection box. In damp areas, such as bathrooms and kitchens, the
-
An Earth connection is prohibited. Do not connect the pilot wire
(black wire) to Earth.
-
Power must be directly connected to the grid after pole disconnection
device in accordance with the installation requirements.
-
If the power cable is damaged, it must only be replaced by an electrician.
-
If you are using the pilot wire and it is protected by a 30mA differential
(e.g.: bathroom use), the pilot wire's power supply must also be
protected on this differential.
Wiring diagram for the device
Cut off the power supply and connect the wires as shown in the fol-
lowing diagram:
Panel heater cable
Phase = Brown
Neutral = Blue
Pilot Wire = Black
Commands
No current
Received
Oscilloscope
Ref/Neutral
Mode
COMFORT
obtained
All manuals and user guides at all-guides.com
ELECTRICAL CONNEXION
Phase
Electricity
Neutral
grid
Complete
altermation
230 V
ECO
2 possible cases:
st
case: One heater
1
nd
2
case: Multiple heater
Negative
Half/altermation
– 115V
ANTI - FREEZE
21
Unpiloted device
Pilot wire not connected
To devices with reception box
or central programming
Positive
Half/altermation
+ 115V
STOP HEATING
LOAD SHEDDING
EN
Werbung
