Klarstein ARIA SMART Bedienungsanleitung Seite 58

EN
58
ASSEMBLY OF THE COMPONENTS
Drive coupler
The drive coupler and rubber seal, if not already installed, must be installed and
secured to the bottom of the blender jar.
To do this, take the drive coupler and make sure the rubber grommet is in place
over the bottom of the coupler as shown below. If you do not attach the rubber
seal, liquids may leak from the bottom of the blender jug.
Lower the drive coupler down from the top of the blender jar and through the hex
hole in the bottom of the blender jar.
Note: The drive coupler can only be fully inserted into the hex hole in three
positions. Not in six positions of the hex hole. Therefore if the drive coupler will
not go all the way into the hole, rotate the drive coupler one notch and push it
in.
Hold the drive coupler and turn the blender jar upside down. With the other hand,
take the locking sleeve and press the locking sleeve down, aligning the arrow on
the sleeve with the unlocked padlock symbol on the bottom of the blender jar.