Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Software
Confirm the followng contents In [Startl - [Settmgsl
Manager] - [CD-ROM] - [MATSHITA
settings If they have not yet been made
e Add a check mark for [DMAI
O Set both [Start dnve letter] and [End dnve letter] In [Reserved (Inve letters] to [L I
Confirm that [Transfer Model IS set to [DMA If availablel In [Start] - [Settings] - [Control
Panell - [System] - [Hardware) - [Device Manager] - [IDE ATA/ATAPI
ondary IDE Channel] - [Advanced Settings] - [Device 01 Perform this setting If It has not
yet been made
Using the CD-R/RW Drive Pack in the MS-DOS Mode
To use the CD-RIRW Dnve PackIn the MS-DOS mode* configure the drive following the
stepsbelow after performmgthe abovepreparationsIf the stepslisted below are performed
without completing above preparations first, the drive will not operate properly.
* In the MS-DOS mode, only CD-ROM discs arc readable
I Sele
ct
]
[Start
2 Sele
ct
t
[Restar
3 Ope
n
the 'CONFI
G
edit config sys
4 Mov
e
the curso
r
"rem" at the beginmng of the line (Deleting "rem ' causesthe Item to becomevalid )
DEVICEHIGH=C
(If this line IS missing, add It )
5
exit the Edit program
6 Follo
w
the sam
e
edit
autoexec
7 Mov
e
the curso
r
at the beglnmng of the line (Deletmg "rem ' causesthe Item to become valid )
LOADHIGH
(If this Ime IS missing add It )
6
Preparation
then s elect [Shut Down)
InMS-DOS model then c hck [OKI
S YS"filefor editing byIssuing
tothe line containin
g
steps toedit t he "AUTOEXEC
bat
tothe line contamin
g
C
(first time only)
IControl Panel] - [System] - [Device
J - Iproper0esl-[Set0ngsl
the following
M
"OAKCDRO
SYS" and d elete the characters
file
BAT" f ile
"MSCDEX
EXEand d elete the characters
EXE [D MSCDOOO
Make the
controllers] - ISec-
commands
SYS [D MSCDOOO
"rem
L
to
Werbung
