Invacare Aquatec Ocean E-VIP Gebrauchsanweisung Seite 11

Assembly and installation
4.8 Fitting the footrests
IMPORTANT
▸ The right and left footrest are each installed in the same
way.
1. Slide footrest A with footplate B inwards into the guide G on seat
frame F until groove E engages in the pin of clip H. The footrest
should no longer turn to the sides.
Setting the footrest height
1. Pull footrest A up a little.
2. Pull out clip H and reinsert it in the desired position. You may need
to pull the footrest out a little further to do this.
3. Press down the footrest until groove E engages in the pin of the
clip.
4. Adjust the second footrest to the desired height as described.
Removing/attaching the heel straps
1. Open the Velcro® fastener on heel strap D.
2. Remove screw C from the underside of the footplate.
3. Remove the screw and flexible pin with the heel strap.
The heel strap is attached in the reverse order.
Shower and Toilet Commode Ocean E-VIP
IMPORTANT
▸ When installing a footrest, make sure that the Velcro®
fastener of the heel strap faces backwards.
Adjusting the heel strap
IMPORTANT
▸ Make sure that the Velcro® fastener of the heel strap faces
backwards.
1. Open the Velcro® fastener on heel strap D.
2. Set the heel strap to the desired length.
3. Close the Velcro® fastener again.
4.9 Fitting the electronics cover
1. Turn both footrests outwards or remove them.
2. Use the hand control to move the shower and toilet commode to
the highest position; see Section 5.4 Controlling, lifting.
3. Remove terminal strip A.
11