Power Connection - Sartorius YDP10BT-0CE Betriebsanleitung

8
Connect the power supply unit
t
to the printer and plug in the jack plug.

Power Connection

Plug the power supply unit into the mains supply.
t
Observe the safety instructions.
3
Make sure that the voltage rating printed on this unit
is identical to your local line voltage. If the voltage
specified on the label or the plug design of the power
supply do not match the rating or standard you use,
please contact your Sartorius office or dealer. Use
only original Sartorius power supply units. The use of
cables from other manufacturers, even if these units
have a registered approval rating from a national
testing laboratory, requires the consent of a qualified
electrician.