Samsung Jet Bot VR30T85 Serie Benutzerhandbuch Seite 9

Operation and maintenance
A. Installation
NOTE
• Install the Clean Station in a place where the
floor and wall are level.
• If the power cord is too long for the
installation environment, coil the power
cord around the cable management post,
then put it in the fixing groove at the rear
of the Clean Station.
• If you reinstall the Clean Station to a
position 1 m or more from the previous
installed place, recreate the map using the
SmartThings App. (If you use the existing
map, some places may not be cleaned.)
B. Using the Jet Bot
B-1 Charging the Jet Bot
Charging
• Open the upper cover of the Jet Bot and
remove the white gasket.
• Remove the yellow gasket attached to the
power switch at the side of the Jet Bot and
press the power switch to turn the Jet Bot
on.
• Place the Jet Bot on the Clean Station
manually to start charging.
- When the Jet Bot starts charging, the
Status Indicator of the Clean Station
turns white and after 1 minute, the
Status Indicator turns off automatically.
(Charging continues though the Status
Indicator has turned off.)
• Check the charging status.
- When charging starts, the Status Indicator
of the Jet Bot turns on (red, orange, or
yellow depending on charging progress),
it rises gradually, and changes to green
when the charging is complete.
Docking (Recharging)
• You can return the Jet Bot to the Clean
Station while cleaning to recharge.
- Press the [ ] on the Jet Bot or use the
SmartThings App to select the recharging
function.
B-2 Starting cleaning
• Press the [ ] on the Jet Bot to start
cleaning in Auto Clean.
• Press the [ ] on the Jet Bot to stop
operation while cleaning.
- When pressing the [
returns to the Clean Station and starts
charging.
C. Cleaning the Jet Bot
Before maintenance work, you should turn off
the power switch at the side of the Jet Bot.
C-1 Emptying and cleaning the Dustbin
• Remove the dust on the filter and the
Dustbin, clean them with water, and dry
completely in the shade.
C-2 Cleaning the brush
C-3 Cleaning the Sensor Window
• Wipe the Sensor Window with a soft cloth.
C-4 Cleaning the Driving Wheel
C-5 Cleaning the Spin Brush
• If curl or deformation occurs, cover the
Spin Brush with a hot steamed cloth for
10 seconds, then wipe the Spin Brush.
D. Cleaning the Clean Station
Before cleaning the Clean Station, unplug the
power cord from the electrical outlet.
D-1 Replacing the Dust Bag
D-2 Cleaning the Fine dust Filter
• Do not clean the Fine dust Filter with water.
NOTE
• For detailed methods of use
and cleaning, refer to the QR
code.
], the Jet Bot
English 9