SAINT-GOBAIN Norton Clipper TR 232 L Bedienungsanleitung Seite 44

VERS. 2019.05.17
5 OPERATING THE MACHINE
You will find in this chapter of the advices to use the machine in a safe way.
5.1 Site of work
5.1.1 Siting the machine

Remove from the site anything, which might hinder the working procedure!

Make sure the site is sufficiently well lit!

Observe manufacturer's conditions for connecting to power supplies!

Place electric cables in such a way that damage is excluded!

Make sure you have a continual adequate view of the working area so you can intervene in the
working process at any time!

Keep other staff out of the area, so you can work securely.
5.1.2 Space required for operation and maintenance
Leave 2 m in front of the machine and 1.5 m around it for usage and maintenance of the TR 232.
5.2 Cutting
To use the TR 232 correctly, you must face it with one hand on the cutting head, and the other on
the material to be cut to maintain it against the material stops. Always keep your hands away from
the moving blade.
The long longitudinal cutting guide and the side extension can help you to achieve high accuracy
cuts, even with large materials.
Important for cutting

Only materials with max. dimensions of 1200x800x15mm and max. weight of 15kg can be cut
with the TR 232.

Before commencing work make sure tools are firmly seated!

Select the right tools as recommended by the manufacturer depending on the material to be
worked, the working procedure (wet cut) to be carried out and the required efficiency.

Make sure the water pan contains enough water.

Use only set with diamonds discs NORTON CLIPPER. The use of other tools can involve the
damage of the machine.

Do not force on the engine. This machine is not designed for a continuous use.
5.3 Cutting with an angle
You can cut from 0º to 45º by tilting the head rail. For this purpose:

Loosen the two knobs maintaining the head rail to tilt the head to the desired angle.

Retighten the two knobs.

According to the angle of cut wished, the position of the handle of the head of cut can be
modified to improve comfort of the user at the time of the cut.
22
TR 232_MAN_EN