Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PRECAUTIONS
FOR
INSTALLATION
INSTALLATION
INSTALLATION
1. Remove original nut (A) and dismount plate (B)
from the frame. (Fig 1)
2. Install BRACKET ② to the frame, using
original nut (A) removed in STEP 1. (Fig 2)
Tightening torque
original nut (A) :60Nm (44.4lbf-ft).
3.
Temporarily fit CLAMP, A ③ and CLAMP, B ④
to left and right of frame, using
CAP HEAD BOLT (M8x18mm) ⑤. (Fig 3) (Fig 4)
NOTE： Pay attention not to damage Water hose (C)
during installation of clamps at left side. (Fig 3)
99000-99031-317
1.
Check that the kit has all the parts as listed in the "CONTENTS" section.
2.
Check each part in the kit for scratches or any form of damage.
3.
Park the vehicle on a level place.
4.
Remove the ignition key from the switch and store it in a safe place.
5.
Protect any items removed or to be installed from scratches by placing them on a soft
cloth first before putting them on the ground.
6.
Use care not to cause any damage to the body of the vehicle during installation of the
accessory.
Fig 1
Fig 2
(A)
Fig 3
2 of 3
(A)
(B)
2
(C)
3
4
5
Left side
201206
Werbung
