BATEC HIBRID Gebrauchsanweisung Seite 44

• Internal resistance: 200 mOhm
• BMS consumption: < 0.2 mA when on; < 0.02 mA when off
• HANDBIKE BATEC HIBRID autonomy:
– HIBRID 2: 55 – 80 km
4.9. WEIGHTS
The HANDBIKE BATEC HIBRID models are equipped with standard
weights to improve traction. The weights are located on the fork, one
on each side. Each one weighs 2.4 kg. To make it easier to transport
the HANDBIKE BATEC HIBRID, the weights can be removed.
• To remove the weights:
1. Hold the weight with one hand, press on the red button and tilt
it so the bottom part comes away from the HANDBIKE BATEC HI-
BRID.
(See fig. 31)
2. Pull the weight out completely.
• To insert the weights:
1. Hold the weight tightly in one hand. Tilt it slightly and insert the
two tabs into the slit on the weight mount slot.
2. Push the bottom of the weight inward until it clicks into place.
fig. 31)
– 34 –
(See fig. 31)
(See fig. 31)
(See
5. INSTALLATION AND ADJUSTMENTS
5.1. INSTALLATION OF THE HANDBIKE BATEC HIBRID ON A
WHEELCHAIR
To anchor a HANDBIKE BATEC HIBRID to a wheelchair, you must
first install a BATEC DOCKING-BAR (pat. pending). The BATEC DOCK-
ING-BAR can be installed on most wheelchairs on the market, whether
fixed or folding frame.
IMPORTANT!
An updated list of wheelchairs compatible with the HANDBIKE BATEC
HIBRID is available in the support section of the BATEC MOBILITY
website.
The HANDBIKE BATEC HIBRID must be installed on a wheelchair by a
qualified professional authorised by BATEC MOBILITY. Contact BATEC
MOBILITY to find the authorised installation professional closest to you.
5.2. USER ADJUSTMENTS
Once the HANDBIKE BATEC HIBRID is properly installed on the wheel-
chair, there are several adjustments that must be made in order to fit
the HANDBIKE BATEC HIBRID to the user's level of mobility, type of
disability and size.
These adjustments can be done easily with the tools and instructions
provided with the HANDBIKE BATEC HIBRID and basic mechanical
knowledge.
The following adjustments can be made:
– 35 –