Akai Reference Master GX-75 Bedienungsanleitung Seite 7

Tarkan
SEPARATED BLOCKS:HIGH RIGIO CONSTRUCTION
SSSETTE DECK GX-75
@ POWER button
To turn the power on and off.
@ Cassette Lid and Holder
Load a cassette tape here.
To open and close the holder, press
the #/4 button.
@ REMOTE SENSOR Window
For reception of the remote control
signal from the optional RC-G75 re-
mote control unit.
Keep away from strong light and di-
rect sunlight as this will interfere with
the remote control function.
@ FL Display
Tells you what the cassette deck is
doing.
@ IPSS (Instant Program Searching
System) Button
To turn the IPSS on and off.
@ MEMORY A-—B Button
To memorize the repeat playback in-
tervals for 2-point repeat playback or
the erase intervals for the spot erase
function.
© REC CANCEL Button
To erase the recorded program dur-
ing recording or to cancel the memo-
rized intervals for the spot erase func-
tion.
© Operation Buttons (<< : Rewind
button, > : Play button, >> : Fast
forward button, ses: REC PAUSE
button, M/2 : STOP EJECT/
CLOSE button, ©: AUTO MUTE
button)
To open and close the cassette hold-
er, to start and stop recording and
playback, to wind the tape and to en-
gage the auto mute mode.
@ COUNTER RESET and MEMORY
Buttons
To reset the digital tape counter to the
"00 min: 00 sec" position and to turn
the memory system on and off.
@® DISPLAY Button
To turn the FL display on and off.
@® CD/DAT DIRECT Switch
( = ON/ m= OFF)
To select between input sources con-
nected to the LINE IN or CD/DAT DI-
RECT IN jacks. For normal recording,
set this button to m .
@® MPX FILTER Switch
( = ON/ m OFF)
To turn the multiplex filter on and off.
@ DOLBY HX PRO Switch
( = ON/ m OFF)
To turn the Dolby HX PRO system on
and off. The Dolby HX PRO system
will affect recording only when the
button is set to = . Otherwise it is
automatically defeated during play-
back.
@® DOLBY NR ON/OFF Switch and
' C-TYPE/B-TYPE Select Switch
To turn the DOLBY NR system on and
off and to select between B type or C
type noise reduction for recording and
playback purposes.
® CAL (Calibration) Switch
(= ON/ m OFF)
To turn the recording calibration sys-
tem on and off.
@ REC LEVEL Controls
(Left -®— Right)
To set the recording input level. The
knob is for left channel level
control and the inside knob is for
right channel level control. For normal
stereo recording the red lines should
be set to the same position.
® BIAS CALIBRATION Control
To adjust the recording bias current
during recording calibration.
The bias adjustment range is be-
tween—20% and +20% ofthe proper
bias current for Normal, CrO2 and
Metal position tapes. Normally set the
control to the center click "O" position.
@® LEVEL CALIBRATION Control
- Toadjustthe recording sensitivity lev-
el during recording calibration.
- The recording sensitivity level adjust-
ment range is between —3% and
+3% of the proper recording sensitiv-
ity level for Normal, CrO2 and Metal
position tapes. Normally set the con-
trol to the center click "O" position.
@ PHONES LEVEL Control
To adjust the output level of the
PHONES jack.
@ PHONES Jack
For headphone connection.
@ TIMER START Switch (REC/OFF/
PLAY)
To select operation of the timer start
function when the power is turned on.