Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Recording
@ Check the cassette tape being used for recording. Make
sure the recording defeat tabs are intact and that the tape's
recording time is of sufficient length.
Before beginning
@ Set the TIMER START switch to OFF.
@ Set the CAL and CD/DAT DIRECT switches to m
.
@ Setthe MPXFILTER switchto m fornormalrecording pur-
poses.
@ Turn on the power of all the components.
After the power is turned on, the operation buttons cannotbe
used for a few seconds while the cassette deck stabilizes it-
self.
;
@ Select the recording source with the amplifier's input selec-
tor or the recording output selector.
Cr
MM
Pane:
GR
GEO
mam D> Se imei
Press the
Mi/#
button and load a cassette tape. Insert
exposed tape side down.
Set the DOLBY NR ON/OFF and C-TYPE/B-TYPE select
switches as follows:
Recording with DOLBY C-type NR...........
ce ceeseeseesseeeeee
Set the DOLBY NR ON/OFF switch to .=
and the
C-TYPE/B-TYPE select switch to =.
.
Recording with DOLBY B-type NR............cessessseseseeeeees
Set the DOLBY NR ON/OFF switch to =.
and the
C-TYPE/B-TYPE select switch to m
.
Recording without Dolby NR ..........:ceseceseseseeseseeseeeteres
Recording level adjustment
Test play the source and set the recording level with the
REC LEVEL controls.
The standard recording level should not exceed the end of
the recording level guide on the peak level meter.
To start recording
Press the ® button.
The [> indicator will stay lit and the SOURCE indicator will
be replaced by the TAPE indicator.
The cassette deck will stop automatically when the end of
the tape is reached.
Press the
a/+
button.
To stop recording temporarily
Press the ses button during recording.
The D> indicator will flash on and off and the TAPE indicator will
be replaced by the SOURCE indicator.
To resume recording
Press the > button.
Notes for recording
@ Set the BIAS and LEVEL CALIBRATION controls to their
center click "O" positions for normal recording.
@ Set the CD/DAT DIRECT button to =
before recording
from the CD/DAT DIRECT IN jacks. Refer to page 20 for op-
eration details.
Set the DOLBY HX PRO buitonto =
for better recording
results.
Standby for recording
Press the see button.
The cassette deck will go into the recording standby mode
and the MONITOR
switch will be automaticaily set to
SOURCE.
The REC and SOURCE indicators will light and the [> indi-
cator will flash on and off.
Werbung
Inhaltsverzeichnis
