Timer Controlled Recording; Timer Controlled Playback - Akai Reference Master GX-75 Bedienungsanleitung

Timer controlled recording and playback
This cassette deck has a built-in timer start function. When
used in combination with an optional audio timer, recording or
playback can be started automatically at any programmed
Timer controlled recording
After preparing for recording, set the timer to the timer opera-
tion mode. The connected audio components will be turned off
automatically.
Set the cassette deck's TIMER START switch to REC.
TIMER START
REC OFF PLAY
time. Refer to the audio timer's operator's manual for operation
deiails.
Timer controlled playback
After preparing for playback, set the timer to the timer operation
mode. The connected audio components will be turned off au-
tomatically.
Set the cassette deck's TIMER START switch to PLAY.
TIMER START
REC OFF PLAY
After timer controlled recording or
playback is finished
Set the TIMER START switch to OFF before turning on the
power of the cassette deck.
Notes for the timer operation
@ Timer start recording or playback will begin 4 seconds after
the power has been turned on.
@ Once the timer start function has begun the operation but-
tons can be used freely for normal recording or playback op-
eration.
Timer controlled recording
@ Make sure your tape is of sufficient length for your recording
needs.
@ Donot forget to tune in the station you wish to record with the
connected tuner, and to set the amplifier for broadcast sta-
tion recording.
@ Normally, keep the VOLUME control set to the minimum po-
sition during timer controlled recording. If you wish to listen
while recording, set the VOLUME control to the normal lis-
- tening level.
Important!
The illustrated power plugs and cords are intended for
general reference. The power cord and plug used in your
country may differ from the illustrations. (Example; U.K.,
Australia, U.S.A., Europe, etc.) ;
25-En
Example connection of the power cord
Tuner
D od MB? coo
Amplifier ;
O BamcD)
$888 en
Household AC outlet
*
If your amplifier is not equipped with AC outlets, con-
nect the power cords to the timer's AC outlet.