Akai Reference Master GX-75 Bedienungsanleitung Seite 14

Conveninent recording features
Recording cancel: Cancelinga _
section that has just been recorded.
Press the REC CANCEL button while the tape deck is in the re-
cording mode.
The cassette deck will rewind the tape to the beginning of the
section that has just been recorded, create a blank space and
then standby for recording.
The REC indicator stays lit, the [> indicator flashes on and off
and the TAPE indicator is replaced by the SOURCE indicator.
To resume recording
Press the ® button.
Notes
® Inorder for recording cancel to function properly, there must
be 4 seconds or more of blank space at the beginning of the
recorded section. To create blank spaces between selec-
tions, use the © button during the recording standby
mode.
@ After recording cancel! has been performed, always make
certain that you are at the beginning of the selection before
re-recording.
Spot erase : Erasing part of a
recorded program
Use the REC CANCEL and MEMORY A-—-B button if you wish
to erase part of a recorded program.
Check before erasing the program
Make sure the recording defeat tabs of the cassette tape are not
removed. The cassette deck will not go into the recording can-
cel mode if they are. Refer to page 5, "cassette tapes" for more
details.
Operation
1 Press the > button to start tape playback.
Memorizing the starting point of the section to be er-
ased
Press the MEMORY A-~B button once at the point you
wish to begin the spot erase function.
The A— indicator will flash on and off.
3 Memorizing the end point of the section to be erased
Press the MEMORY A-— 8B button again when you reach
the point at which you wish to end the spot erase function.
The A-—B indicator will appear and the cassette deck will
stop.
To start erasure
" MEMORY A—B
Button
REC CANCEL
Button
To confirm the portion to be erased
(Before beginning erasure)
After operation 1,2 and 3, press the > button for playback.
The cassette deck will go into the repeat playback mode. After
the memorized portion is played, the cassette deck will stop au-
tomatically.
After confirmation
Press the REC CANCEL button to start erasing.
When the end of the section to be erased is reached, the
A indicator will disappear and the cassette deck will stop
automatically.
To cancel the spot erase function
Press the Hi/# button.
The A-—B indicator will disappear.
Erasing a short section of tape during
playback
After playback has begun and you are near the portion of tape
you wish to erase, depress the ® button for approx. 1 second.
The cassette deck will go into the half speed playback mode.
The [> indicator will flash on and off during half speed playback.
Press the MEMORY A-—8 button and REC CANCEL button as
in the previous procedures 2 to 4 to erase the desired section.
To resume normal speed playback during half speed
playback
Press the » button again.
The [> indicator will stay lit.
Notes
@ Tape check: Before erasing the tape, take up slack with a
pencil.
@ When erasing tape in the half speed playback mode, confir-
mation of the portion to be erased can be made asin normal
playback.
@ During half speed playback, other functions such as record-
ing, rewinding or fast forwarding cannot be used. The only
button that will operate when pressed is the Mi/#. button
stop the cassette deck.