Werbung
Verfügbare Sprachen
Verfügbare Sprachen
'Self-help ore ee
Problem
|
Mains indicator
does not come on
Machine does not start
Water not pumped away
Cleaner lid will not close
Lower spray arm
rotates with difficulty
White deposits
left on dishes
Streaks on glassware
Utensils still wet
after drying cycle
Rattling noises
Unsatisfactory
washing results.
26
Possible cause
The main switch has not been turned.
Plug not properly inserted in socket.
Fuse blown or circuit breaker tripped in house.
Machine door not properly closed.
Left dial not in starting position (Fig. @/2).
Water tap not on.
Filter clogged in inlet water hose.
Kink in drain hose.
— Filter clogged.
(Check coarse and fine filters Fig. ©).
— Programme is not completely finished.
— Pull off and clean spray arm.
Clean also spray arm mounting.
- Incorrect amount of detergent or rinse-aid.
- No granular salts in the water softener.
— The lid of the granular salt storage container
was not securely screwed on.
- Too much rinse-aid.
— Too little rinse-aid.
— Utensils not properly arranged.
- Incorrect amount of detergent or rinse-aid.
- Programme selector turned accidentelly after filling
detergent container.
This releases detergent too soon.
- Utensils incorrectly arranged or rack overloaded.
- Spray-arm rotation obstructed by utensils.
— Coarse or fine filter clogged (Fig. ®).
- Microfilter clogged (Fig. ®).
(If needed remove and clean them.
Be sure the microfilter clicks securely back into place).
— Filters not properly fitted into position.
.
— Clogged nozzles in spray-arm.
— Unsuitable programme selected.
Werbung
