Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Turning on the appliance
— Check that the motion of the spray-
arms (Fig. @/15 and @/19) is not
hindered by utensils. |
If applicable, remove any obstacle.
- Close door of the appliance
- Turn on water tap fully
- Press button corresponding to the
selected programme (Fig. @/6)
- Turn the left knob
(Programme starter Fig. @/1) only as
far as the starting position (Fig. @/2).
- Press the main switch. (Fig. @/5)
Mains indicator will come on.
(Fig. Q/7)
The program will begin.
If the left dial (program starter Fig. @/1)
is turned 360 degrees clockwise,
the detergent container will open.
Should the container be full at the time,
the contents will be released,
and more detergent will then
have to be added.
Turning the machine off
— Depress the main switch. (Fig. @}/5)
Mains indicator will go off. (Fig. €}/7)
- Turn off the water tap.')
The program button can remain
as it is. (Fig. @/6)
The left dial (Fig. @/1)
may remain as it is.
— If you have only used the
pre-rinse cycle, turn the left dial
(program starter Fig. @)/1)
clockwise to the program end
until the mark on the dial is up.
') This does not apply in the case
of appliances equipped with Aqua-Stop.
24
Programme sequence
indicator
!
The symbols stand for the following washing
phases:
mm
Wash
"3 Intermediate and final rinse
$M
Drying
The programme sequence indicator moves
during the programme to show the particular
washing phase taking place during a washing
cycle.
Changing the programme
The selected programme may be changed any
time. To do this, simply press a button for a
different programme (Fig. @/6).
The new programme will begin immediately.
Interrupting the programme
If the programme needs to be interrupted,
press the main switch (on/off) button
(Fig. @/5).
Push the same button again for the
programme sequence to continue.
If the dishwasher is connected to a hot water
supply, or if changing the programme after the
dishwasher has heated the water, open the
door of the dishwasher and leave it ajar for a
few minutes before closing it again.
Time Delay")
The programme start can be delayed from
1 to 9 hours.
— Turn the left knob (programme starter
drawing @/1) only as far as the start
position (drawing @/2).
- Press programme button.
—
- Press main switch (drawing @/5).
Time delay indicator lights up.
Now press the time delay button (drawing
@/11) until the desired number of hours
appear in the display.
The programme will start after the number
of hours shown in the display have expired.
2) Not on all models.
Werbung
