Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ete
Sg
In order to work correctly,
the dishwasher needs soft water.
So a water softener is built-in.
When correctly set,
it softens the water.
Setting the water softener
Your local water board will tell you
what the water hardness in your area is.
The water hardness dial should then
be set as shown in Fig. @.
Important Note!
Please make absolutely sure that the lid (flap)
on the salt container is closed properly.
Soap suds must not get into the salt container.
Never put detergent into the salt container, as
the water softener would be damaged and a
guarantee claim could not be made against
this damage.
Only use granular salt
suitable for dishwashers
Fig. ©
.
Before using the machine for the first
time pour approximately 1 liter of water
into the salt container. This helps to
dissolve the salt more quickly. Only use
granular salt suitable dishwashers.
To fill container, remove lower basket.
Unscrew cap of salt container (Fig. @/14),
and fill with granular salt.
.
Filling can be made easier by using a
pouring cup.
.
Then screw cap tightly back into place.
Dishwasher granular salt is suggested.
When using salt tablets, do not fill
the container to the top.
Table-salt, road-salt or any other salt
should not be used. These salts usually
contain insoluble elements, which in time
can damage the softener.
(Granular salt can be obtained in most
large supermarkets).
The reserve container holds about 1.5 kg
of granular salt.
After the first wash cycle,
the salt container
will be full of water.
So adding salt should always be done
immediately before starting
the dishwasher. This way,
any excess salt solution will be
immediately thinned and washed away.
Low salt indicator
In a hard water area salt must be added
as soon as the flooter can no longer
be seen (Fig. €}/23) or it goes on
(Fig. @/8).
Werbung
