Troubleshooting; Maintenance Schedule - Parkside PGI 1200 B2 Originalbetriebsanleitung

Troubleshooting

Fault
Engine cannot be started.
Generator has too little or no voltage.

Maintenance schedule

The following maintenance schedule must be complied with to ensure trouble-free operation.
CAUTION!
► Before first use, engine oil and fuel must be filled in.
Before every use
Check the
engine oil
Change the
engine oil
Check the
air filter
Clean the
air filter
Clean the
fuel filter
Visual inspection
of the appliance
Clean the
spark plug
Check and
adjust the
throttle valve
Clean the
cylinder head
Set the valve
clearance
ATTENTION: Points marked "X*" may only be carried out by an authorised specialist workshop.
PGI 1200 B2
Cause
Automatic oil switch-off activates.
Soot deposit on spark plug .
No fuel.
Electronics defective.
Overvoltage safety switch has been
triggered.
Air filter soiled.
after 20 hours of
operation
X
for the first time,
and then
every 50 hours
X
X
Measure
Check oil level, add engine oil.
Clean or replace spark plug .
Electrode gap at 0.6 mm.
Add fuel / check fuel tap
Contact specialist retailer.
Restart generator, reduce consumers.
Clean or replace filter.
after 50 hours of after 100 hours of
operation operation
X
X
Gap: 0.6 mm,
replace if
necessary
.
after 300 hours of
operation
replace filter pad
if necessary
X
X*
X*
X*
GB │ MT │ 19
■