Troubleshooting; Engine Unit; Pole Pruner; Hedge Trimmer - Parkside PBK 4 A1 Originalbetriebsanleitung

Troubleshooting

Engine unit

Problem Possible cause
The engine does
Incorrect start-up process.
not start.
Incorrect adjustment of the
The engine starts
choke lever
but does not run
at full power.
Contaminated air filter.
The engine does
Incorrect spark plug gap.
not run smoothly.
Soot deposits or
Incorrect carburettor
wetness on the
adjustment.
spark plug.

Pole pruner

Problem Possible cause
Hedge trimmer attachment
Motor is running,
or pole pruner attachment
saw chain
is not connected properly
does not move.
to the engine unit.
Saw chain
No progress.
heating or is sagging.

Hedge trimmer

Problem Possible cause
Hedge trimmer attachment
Motor is running,
or pole pruner attachment
blades do not
is not connected properly
move.
to the engine unit.
│ GB │ MT
■ 34
Troubleshooting
Follow the instructions
regarding starting.
Set the choke lever
.
to " ".
Clean air filter.
Clean the spark plug
and adjust the spark
plug gap or replace
the spark plug.
Clean spark plug or
replace it with a new
spark plug.
Troubleshooting
Check assembly.
Top up the oil or reg-
dry/over-
rind, replace or tighten
the saw chain
Troubleshooting
Check assembly.

Maintenance intervals

Pole pruner
The figures given here are based on normal operating conditions. In the
event of more difficult conditions, such as strong dust generation and
longer daily operating hours, the given intervals are to be reduced corres-
pondingly.
Appli- Action
ance part
Lubricat-
ing the Check
chain
Check and pay
saw attention to
the sharp-
chain
ness
Check
chain
tension
sharpen
Check (wear,
guide damage)
rail
clean and
turn
deburr
.
replace
Check
sprocket
replace
Hedge trimmer
The figures given here are based on normal operating conditions. In the
event of more difficult conditions, such as strong dust generation and longer
daily operating hours, the given intervals are to be reduced correspond-
ingly.
Appli-
Action
ance part
Cutting Visual inspection
blade
Cleaning

Ordering spare parts

Ordering spare parts
The following information should be provided when ordering spare parts:
■ Type of appliance
■ Item number of the appliance
■ Device ID number
Current prices and information are available at
www.kompernass.com
NOTE
■ Replacement parts which are not listed (e.g. strimmer, cutting filament)
can be ordered via our service hotline.
Before Weekly In the In the
starting event event
work of of dam-
faults age
X
X
X
X
X X
X
X
X
After
Before
com-
starting
pletion
work
of work
X
X
PBK 4 A1
As re-
quired
X
X
X
As re-
quired
X