Klarstein Presidente 65 Bedienungsanleitung Seite 12

EN
12
PRODUCT DESCRIPTION
1 Drawer
2 Hygrometer
3 Door
4 Shelf
INSTALLATION
This cooler is freestanding unit and should not be installed inside a cabinet or other built-
in enclosure. For proper ventilation, allow 5 inches clearance between the back of the
unit and any adjacent walls. Before operating your cigar cooler for the first time, follow
these steps:
• Before connecting the unit to a power source, allow it to stand upright for
approximately 2 hours. This will reduce the possibility of any system malfunctions
which may have occurred from handling during transportation.
• Clean the interior surface of the unit with lukewarm water and a soft cloth but do not
get the wood wet.
• Place the cooler on a level surface that will be strong enough to support the unit
when it is fully loaded. To level your cooler, adjust the front feet located at the
bottom of the unit.
• Install the cooler away from direct sunlight and heat sources such as stoves, heaters,
or radiators. Direct sunlight may affect the unit's acrylic coating, and nearby
heat sources can increase electrical consumption. Extreme cold or hot ambient
temperatures may also prevent proper performance.
Note: The appliance is not designed for commercial use. It is intended for use in
domestic households and in similar working and residential environments, such
as staff kitchen areas, farm houses, hotels, motels and bed and breakfast type
environments.