Disposal; Troubleshooting - Hilti WSR 1200-PE Bedienungsanleitung

Disposal

Most of the materials from which Hilti power tools are manufactured can be recycled. The materials must be cor-
rectly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking
back your old electric tools for recycling. Please ask your Hilti customer service department or Hilti sales repre-
sentative for further information.
Should you wish to return the electric tool yourself to a disposal facility for recycling, proceed as follows: Dismantle
the tool as far as possible without the need for special tools. Use absorbent paper to wipe lubricated parts clean
and to collect the grease that runs out (total quantity approx. 50 ml). This paper should also be disposed of cor-
rectly. On no account should grease be allowed to enter the waste water system or to find its way into the
ground.
The individual parts should be separated as follows:
Part / assembly
Toolbox
Outer casing
Gear housing
Grip
Electronics module and switch
Fan
Motor (rotor and stator)
Supply cord
Gearing parts
Screws, small parts

Troubleshooting

Symptom
The tool doesn't start
Tool doesn't produce full
power
Orbital action does not react
Saw blade cannot be
removed from the blade clamp
Printed: 07.07.2013 | Doc-Nr: PUB / 5071340 / 000 / 00
Main material
Plastic
Plastic / elastomer
Magnesium alloy
Plastic
Various
Plastic
Steel and copper
Copper, elastomer sheath
Steel
Steel
Possible cause
Fault in the electric power supply
Defective supply cord or plug
Switch defective
Cross-section of the
extension cord is inadequate
Stroke rate regulator set to "low"
Control switch is not pressed fully
Function switch not set to
orbital action
Locking sleeve not turned
as far as it will go
Recycling
Plastic
Plastic
Scrap metal
Plastic
Electronics scrap
Plastic
Scrap metal
Scrap metal
Scrap metal
Scrap metal
Possible solution
Plug in another electric tool and check
whether it starts
Have it checked by an electrical
specialist and replace if necessary
Have it checked by an electrical
specialist and replace if necessary
Use an extension cord of adequate cross-
sectional area. See section "Preparation
for use"
Set stroke rate regulator to position 4
(fig. )
Press the control switch as far as it will go
Set function switch to orbital action
Orbital action is perceptible only when
sawing.
Turn locking sleeve as far as it
will go and remove saw blade
15