Care And Cleaning; Fixing Occasional Malfunctions - SANTIS Hygo Magic Gebrauchsanweisung

Care and cleaning

The maintenance of the Hygo Magic is simple, as it has been
made of modern materials. Yet, it is important to keep some
basic rules to preserve its usage value and attractive
appearance.
The cleaning of the coverage and the seat should be done with
current gentle cleansing agents. Acidic or caustic dissolvent
must not be used.
The device must not be cleaned by blast of steam or any high-
pressure equipment, also avoid using running water.
The device must not be used in rooms where the temperature is below
freezing. Though it must not be exposed to direct heat either (radiator,
fan heater).
During cleaning pay attention to keep the paper dry!

Fixing occasional malfunctions

1. The paper clamping equipment did not remove the paper
Stop the seat while it is moving and hold it for 5 seconds, the device will
shut down
- Check whether anything is stuck between the paper-clamping
rubber and the plastic. If you find something, remove it.
- Check the cleanliness of the rubber. If it is dirty, clean it.
2. The upper infra-sensor operatest he device unwanted
- Clean the sensor case with a dry cloth or gentle detergent.
3. The seat does not release the paper
- Clean the „back sensor" case with a dry cloth or gentle detergent.
4. After removing the paper, the seat will not turn into its normal
position
- Clean the sensor case, which is built int he seat, with a dry cloth or
gentle detergent
In case of any other malfunctions, please contact our customer
GB 12
service!