Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mounting the voltage source
Installation in a cavity wall
1.
Make a recess of H x W: 194 x 252 mm in the wall. Therefore, use the template supplied.
The flush-mounted box must later be flush with the plastered wall.
2.
Glue or screw the two wooden blocks supplied into the cavity wall.
3.
Depending on the cable position, press the circular plates at the top or bottom out of the
box and insert the supplied self-sealing grommets to prevent damage to the cable.
4.
When inserting the flush-mounted box, route the supply and communication cables (Ether-
net, KNX) through different holes in the flush-mounted box to avoid possible interference.
5.
Screw the flush-mounted box on the sides to the wooden blocks using the four screws.
6.
Use the template as a splash guard during the filling of the edges.
Mounting the voltage source
Note:
In case a power supply unit is used in the flush-mounted box, you will find the corre-
sponding instructions in the manual
Avoid electric shock when touching live parts!
Disconnect all associated circuit breakers before working on the device.
▪
▪
Cover live parts in the surroundings.
20
Warning
Werbung
Inhaltsverzeichnis
