Werbung
amt o® ©
©
Microphone
Microphone
Mikrophon
Stereo microphone mixer MX-6S
Melangeur
de microphone stereo MX-6S
Stereo
Mikrophon
Mischpult MX-6S
STEREO PLAYBACK
Set up the stereo playback
system.
Turn the AC power of each component
ON.
Place the recorded tape on the Feed Reel Spindle with the
side
1 up
and
place
an
empty
reel
on
the
Take-up
Reel
Spindle.
vv When the recorder is used in vertical position, place the
supplied
Reel Caps on the spindles.
4.
Thread the tape through the tape path of the Head
Cover.
5.
Set the Tape
Speed
Selector to the required
speed of the
recorded
tape.
6.
Set the Function
Selector to [>]
position.
The tape will
begin to move forward.
Track-1
and track-3 will be played
back.
7.
Adjust
the
volume
and
tone
controls
of the
connected
amplifier.
8.
To play back track-4
and
track-2,
invert and
reverse
the
tape reels.
WN
i
For fast forward
.
If you want to listen to the
programs
from
the middle of the
tape,
turn
the
Function
Selector
to [ >» ]. When
the
tape
reaches the desired position, turn the Selector to [@] position
and turn it again to [»] position.
For instant
stop
To
stop
tape
motion
instantly
at any
desired
time,
turn
the
Function Selector to [@] position.
For private
listening
Connect the SONY Stereo Headphone DR-5A (optional accessory)
or any 8 ohm
stereo
headphone
to the Headphone
Jack.
The
line output
level of the
Headphone
Jack
is fixed
at a pre-
determined
point,
therefore,
the
volume
of the headphone
is
always constant.
MONOPHONIC PLAYBACK
The
following
playback
procedure
is
recommended
for
a
monophonic
tape
whose
sequence
of
recording
is; track-1,
track-4, track-3 and track-2.
Set up the amplifier-speaker
system.
Place the recorded tape with side
1 up and thread
the tape.
Turn the AC power of each component
ON.
Set the mode selector of an external amplifier to [L] position.
Set the Tape Speed Selector to the required speed
of the
recorded
tape.
Set the
Function
Selector to [>]
position, the
tape will
begin to move
forward.
Track-1
will be play:d
back.
Adjust the tone, volume and other controls ofthe connected
external
amplifier to reproduce
the left channel!
sound.
When the end of the tape
is reached,
do mt
rewind the
tape.
Invert and reverse the tape reels to play back track-4.
To
playback
track-3
and
track-2,
adjust
the
amplifier
for
right channel
reproduction.
Then
repeat
the
procedure
of
track-1
and track-4
playback.
oS oe N fF APYWNE
CONNECTION
INFORMATION
Microphone
Inputs
Werbung
