Werbung
10
Idler shaft
Axe libre
Roulette d'entrainement
Andruckwaize
SPLICING TAPE
1.
Use
splicing
tape
and
a
pair
of
scissors.
Do
not
use
ordinary cellophane tape as it tends to deteriorate.
2.
Overlap the tapes to be spliced and
make
a diagonal
cut
across the overlapped position.
3.
Place a piece of splicing tape on a flat surface, pasty side up.
On
the
splicing
tape,
put
and
press
the
two
diagonal-
tape-ends,
shiny side down.
¢y Be careful to make
ends
meet,
but not overlap.
x The two tapes spliced must make a straight line.
4.
Trim off the excess splicing tape.
MAINTENANCE
Cleaning heads
Optimum
performance
will be assured by clean heads.
Remove
the head cover by loosening the screws at the rear of the cover.
Take the supplied head
cleaning tip or a soft cloth
and wipe
the heads and the tape guide over which the tape travels.
When
the deposits
cannot
be
removed,
moisten
the tip or the cloth
with denatured alcohol and repeat cleaning.
Demagnetizing
heads
Although the TC-252D incorporates a circuit to demagnetize the
record head, under certain conditions such as prolonged playback,
residual
magnetism
would
gradually
build
up
on
the
heads,
causing degradation of tapes.
Periodic use of the SONY
HE-2
head
demagnetizer
is
recommended
to
maintain
optimum
performance,
Lubrication
Use light machine oil and lubricate capstan, pinch
roller shaft
and idler shafts
every 6 months.
Avoid excessive
lubrication.
It will cause slippage of the mechanism
and contamination
of
your tape.
Remove the Function Selector by loosening the screw
located
beneath
the lever.
Remove
the head cover, Tape Speed
Selector
and
four screws
from
the top panel
of the recorder
and lift up the panel.
Take out the caps of the pinch
roller and
the three idler shafts.
Lubricate
the capstan,
the idler shafts
and the pinch
roller shaft with
1 drop each of light machine oil.
Werbung
