Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2. How to use
2.1 Before use
•
Remove shipping package, tape, etc., and leave doors open for ventilation for a while.
•
The unit is cleaned before shipment. However, clean the compartment interior once after delivery.
•
Please insert power supply plug into the wall outlet, single-phase to cat voltage.
•
Allow the unit to operate for about 1 hour to cool the compartment before placing items in the cooler.
WAIT 5 MINUTES OR MORE BEFORE RE-STARTING
•
Restarting the unit immediately after it has been turned off may cause fuses to blow and activate the circuit-
breaker, the compressor may be overloaded and/or other damage may occur.
2.2 Temperature adjustment
For showcase cooler, the interior temperature during fully loaded at factory default setting of position at 4-
•
5 will be kept at 0-10°C. If the ambient temperature is extremely high or the stuffing food inside is too much,
that might cause the interior temperature a little bit higher. So, it would be better turn the thermostat right
so as to maintain the right temperature. On the opposite, if the ambient temperature is very low or empty
loaded, or in less food storage, the interior temperature might be able to reach minus 0°C, and in return to
cause the evaporator ice up; Thus, it would be better to switch the thermostat back to left so as to relieve
something.
2.3 Drain tray
•
Defrosting is performed automatically and drain water is collected in the drain tray.
•
Water in the drain tray is evaporates automatically. In humid surroundings, there will be large amounts of
water in the drain tray, so please throw away drain water once a day.
2.4 Efficient use
Please follow the instructions below, to save energy.
To prevent cold air from escaping, open and close the door quickly and keep the door opened for as short a
•
time as possible.
•
Please install the unit in the place which is well-ventilated.
2.5 Shelf height adjustment
The shelf height can be adjusted. Arrange the shelves in accordance with the dimensions of the items to be
placed in the cooler.
2.6 Placing items in the showcase
This showcase employs a forced circulation of cold air system. If circulation of cold air is obstructed, the items
will not be adequately refrigerated. Pay attention to the following points:
•
Do not let items obstruct the cold air inlet and suction outlet.
•
Place items so that they do not protrude from the shelves. The gap between the shelves and the door is
used for circulation of cold air.
Place items evenly on all shelves.
•
Please do not display goods on the bottom. Please put goods on the shelf.
•
www.combisteel.com
7
Werbung
