Sharp RP-103H Bedienungsanleitung Seite 6

Check the setting of the AC voltage selector located on the rear
panel before plugging the unit into an AC outlet. If necessary,
adjust the selector to correspond to the AC power voltage used
in your area.
Selector adjustment:
Turn the selector with a screwdriver until the appropriate voltage
number appears in the window. (110V, 220V or 240V)
( b6 not use force when pressing or pulling the coor. )
* POWER SWITCH
Turn the switch ON when using. When finished using,
press the switch to place the unit in © STAND-BY.
e@ Unplug the AC supply lead when not being used for
prolonged periods of time.
At time.the turntable platter may not operate when
the PLAY/CUT button is pressed immediately after
turning the POWER switch ON... This is because of
the micro-computer -which needs a short: - interval
until it is ready. to operate. Wait a few seconds and
try again. b .
=
*x OUTPUT CABLES
These cables are especially designed for use with the
stereo receiver SA-103H and therefore units other than
SA-103H should not be connected,
When opening or closing the turntable compartment, do it
gently.
*PLAY/CUT BUTTON
When the turntable compartment is open, the pressing of
this button will close it and the record will begin playing.
* RECORD LOADING BUTTON
With the power ON, press this
button to open the turntable
compartment.
eThe compartment will not
open if the power is on ()
STAND-BY.
e If the button is pressed while
a record is playing, the
record will stop and the
compartment will open.
* SIDE A/B INDICATOR
When the POWER switch is turned ON, the side A indi-
cator (green) will always light up.