Streetz TWS-0007 Bedienungsanleitung Seite 2

ENG
1. Charge port (USB Micro-B)
2. Charge LEDs
3. Charging button
4. Charging contacts
5. LED and button
On/off/next/previous/answer/hang up
POWER ON AND OFF
Take the earbuds out of the charging case, they will
automatically power on.
Place the earbuds in the charging case to automati-
cally power them off.
Or press and hold the buttons for about 3 seconds to
power them on, 5 seconds to power them off.
CHARGING
Insert the earbuds into the charge case to charge
them.
The charging contacts should be well connected.
Charge the charging case via a Micro USB cable.
The charge case's LEDs: Flashing red indicates it
is charging, solid red indicates fully charged and
solid blue indicates it is charging earbuds. When the
earbuds' LEDs are turned off, it indicates they are
fully charged.
If the earbuds are already in the case, you can press
the charging button on the case to start charging.
CONNECT
1. Take out the earbuds from the case. They will
power on and connect to each other.
2. The right earbud's LED will flash red and blue
indicating ready for connection.
3. Connect to the earbuds from your phone/device.
Refer to your phone/device manual if needed.
USAGE
Gently put the earbuds into your ears.
These earbuds can be used as a single earbud or
dual earbuds. If you want to use a single earbud,
just power on one of them. Usage and connect is the
same otherwise.
ANSWER AND HANG UP
Press the button to answer or hang up a phone call.
DECLINE A PHONE CALL
Press and hold the button for about 2 seconds.
PLAY/PAUSE
Press the button to play/pause.
NEXT SONG
Press the button 2 times for next song.
PREVIOUS SONG
Press and hold the button for about 2 seconds for
previous song.
VOLUME
Adjust the volume from your connected device.
(eg. phone)
WARNING
1. Never disassemble or modify the product to avoid
damage to the product and to avoid danger.
2. Do not store in extreme temperatures
(below 0°C or over 45°C).
3. Do not use harsh chemicals or strong detergents
when you clean this product.
4. Keep dry.
5. To avoid hearing damage, make sure that the
volume is set to low before connecting. Gradually
turn up the volume until you reach a comfortable
listening level.
1