Schneider Schirme Rhodos Montage- Und Bedienungsanleitung Seite 42

EN
Assembly
Place the two elements of the cross base (A + B) one on top of the other as
shown and screw firmly to the rotating plate (D).
Use the screws M8x20 (F) and one washer (G) for each screw.
Then bolt the tube (C) to the rotating plate (D).
Use the screws M8x14 (E) and one washer (G) for each screw.
NOTE:
The tube slants backwards at an angle of3°.
This is intentional and is not grounds for
complaint.
The slanted design of the tube prevents the
pole from hanging forward when the umbrella
is open and also gives the umbrella an overall
elegant appearance.
42