Horizon Oxford 3 Bedienungsanleitung Seite 112

BASIC OPERATION
FREE AREA
0.6 (2
m ft
112
LOCATION OF THE ROWER
Place the Rower on a level surface.
For ease of access, there should be an
accessible space preferentially on both
sides and the rear of the Rower that is at
least 0.6 meters (24 inches). Do not place
the Rower in any area that will block any
vent or air openings. The Rower should
not be located in a garage, covered patio,
near water or outdoors.
ROWER FOOTPRINT
Oxford 3 - 205 x 62 cm / 80.7" x 24.5"
Oxford 6 - 210 x 62 cm / 82.7" x 24.5"
)
ROWER WEIGHT
Oxford 3 - 40 kg / 88 lbs.
Oxford 6 - 41 kg / 91 lbs.
1
2
MOVING THE EQUIPMENT
To move, firmly grasp rear frame and tilt
the equipment up (1) and roll (2).
STORAGE
Fold console down (3). Tilt the frame
into the upright position (4).
WARNING!
Our equipment is heavy, use care and
additional help if necessary when moving
or standing up. Failure to follow these
instructions could result in injury.
4
3
CAUTION!
Caution should be used when storing rowers
in an upright storage position. Rowers have
been tested for stability when stored in
an upright storage position. While testing
has shown that the rowers can maintain
their stability when tilted up to 10 degrees,
accidental contact with an upright rower
may potentially knock over the rower.
• Care should be used when handling
rowers in the upright storage position.
• Any rower stored in the upright storage
position shall be stored in a protected
area to prevent accidental contact with the
rower.
• Unless people are storing a rower or
retrieving a rower from storage, keep
people away from upright stored rowers.
LEVELING THE EQUIPMENT
It is extremely important that the levelers are
correctly adjusted for proper operation. Turn
leveling foot clockwise to lower and counter-
clockwise to raise unit. Adjust each side as needed
until the equipment is level. An unbalanced
unit may cause belt misalignment or other
issues. Use of a level is recommended.