Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.
If you have not mounted the lamp on a tripod, place it on a work table
with the illuminated surface facing upwards.
4.
Open the upper shielding flap (3).
5.
Loosen the holder (1).
6.
Slide the diffuser (2) from above into the supporting rails of the
housing.
→ Pay attention to the alignment!
7.
Close the holder (1) again.
7.5 Setting the brightness / dimmer on the fixture
1.
Switch on the lamp as described in the chapter 6.
2.
Turn the rotary knob (6) to the right or left until the desired brightness
is reached.
→ The selected % value is shown in the display (10). The setting range
is 1-100%.
7.6 Setting the color temperature on the lamp
1.
Switch on the lamp as described in the chapter 6.
2.
Turn the function knob (7) to the right or left until the color temperature
corresponds to your idea.
→ The corresponding color temperature in K is shown in the bottom
line of the display (10). The setting range is 3,200 - 7,500K.
7.7 Controlling the lamp via Bluetooth and app
You can control the lamp via Bluetooth and the Instarter Spectar LED app in
the self-explanatory app.
7.8 Set effects
1.
Switch on the lamp as described in the chapter 6.
2.
Briefly press the function knob (7) to activate the effect function (15).
36
Werbung
