Werbung
Verfügbare Sprachen
Verfügbare Sprachen
■ Always operate the lamp with two batteries of the same capacity and
similar state of charge.
■ Always change both batteries at the same time.
■ If you operate the lamp with mains power, remove the batteries to be
on the safe side. The batteries are not charged in the lamp and could
become very hot or damaged.
6.4 Disconnect the power supply
NOTE - Switch off the lamp after use and disconnect
mains if you are not going to use it for a longer period of time.
Operation via mains adapter
1.
Switch off the lamp. To do this, move the on/off switch (8) to the
position [0].
2.
Pull the mains plug out of the socket.
3.
Pull the plug of the power supply unit out of the socket (5) at the
back of the lamp.
Operation by battery
1.
Switch off the lamp. To do this, move the on/off switch (8) to the
position [0].
2.
Remove the batteries from the battery docks (11).
7.
Operating and handling of the lamp
7.1 Using the LED lamp
WARNING
Danger from heat, electricity or fire
The lamp and especially the illuminants reach temperatures of up to
60° C during operation. The lamp can overheat (icon
if you operate it with the ventilation slots covered. In case of overheating
or short-circuiting, the fixture itself and easily flammable materials near
the fixture may start to burn.
the lamp
from the
in the display)
EN
33
Werbung
