Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Swivelling
1.
To swivel, loosen the two locking screws (12) slightly.
2.
Tighten the two locking screws (12) again in the desired position.
7.3 Adjusting the barn doors
The lamp is supplied with pre-assembled shielding flaps (3). Open the
shielding flaps (3) one after the other and adjust them as desired.
Close the shielding flaps during transport or storage so that the lamps are
protected and nothing sticks out.
7.4 Disassembly / assembly of the diffuser
The lamp is delivered with the diffuser (2) pre-assembled. The diffuser (2)
is held from the lamp housing by supporting rails on the housing and fixed
in place by a bracket (1) .
Removing the diffuser
1.
Fix the lamp to the stand by tightening the fixing screw of the
bracket (4).
2.
Fix the two locking screws (12), so that the lamp can no longer turn
or tilt.
or
3.
If you have not mounted the lamp on a tripod, place it on a work table
with the illuminated surface facing upwards.
4.
Open the upper shielding flap (3).
5.
Loosen the holder (1).
6.
Pull the diffuser (2) upwards out of the supporting rails of the housing.
7.
Close the holder (1) again.
8.
Store the diffuser in a safe place so that it is protected from scratches
and damage.
Insert diffuser
1.
Fix the lamp to the stand by tightening the fixing screw of the
bracket (4).
2.
Fix the two locking screws (12), so that the lamp can no longer turn
or tilt.
or
EN
35
Werbung
