Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Preparing for use
Attach wheels and unfold
Insert the hand rim wheels into the hole provided in the
Varioblock by pressing the release button in the center
of the hub. Ensure that the wheel is properly locked af-
ter insertion; check this by pulling outwards (photo 2+3).
Now unfold the wheelchair by pressing on the seat sur-
face until it noticeably clicks into place.
Hanging the footrests
Hang both footrests provided as shown and swivel them
inwards until they audibly click into place (photo 4+5). To
release the footrests, press the lever inwards and swivel
the footrests to the side (photo 6).
4
5
Never swivel the footrests inwards!
Length and angle adjustment
of the footrest
Length adjustment
(photo 7)
Use the enclosed Allen
wrench
to
loosen
the
screw on the footrest and
adjust the length as desi-
red by shifting up or down.
Retighten the screw!
Drive Medical GmbH & Co. KG | As per: 26.05.2023 | Errors and alterations excepted
Angle adjustment
(photo 8)
Use the enclosed Allen
wrench to release the
screw on the footrest until
it can be pulled out of the
toothed wheel inwards.
Now rotate the footrest
into the desired position
and press it back into the
toothed wheel.
Retighten the screw!
Adjusting seat height (rear wheel mount)
The height of the seat at
the rear can be adjusted
in increments. To adjust
it, remove both hand rim
wheels by pressing the re-
lease button (see section
"Attach wheels"). Unscrew
the nut of the wheel mount
and move it into the desi-
red hole.
Replace the nut with the
locking washer and tigh-
ten it (photo 9).
Ensure that the wheel axle is properly tightened!
6
Adjusting seat height (front wheel mount)
The height of the seat can
be adjusted in increments
and is correspondingly ad-
justed in the desired incli-
nation of the seat surface.
To adjust, unscrew the
wheel axle screw and pull
it out.
The plugs of the corres-
ponding holes can be ea-
sily exchanged. Now move
the wheel in the desired
position and reinsert the wheel axle screw and tighten
it (photo 10).
Ensure that the wheel axle is properly tightened!
EN
17
Instructions for use ROTEC
Werbung
