JSP AFP-25 Bedienungsanleitung Seite 8

With the faceshield and WBS mounted to the helmet, move
the faceshield to the deployed/working position to check the
browguard is positioned over the front of the EVO
shell. Lift the faceshield until the triangle marking on the
WBS base lines up with the marking on the WBS arm. This
allows the arm to slide to the axle. When the faceshield is
secured you will hear a click sound.
The WBS is now mounted and ready for use.
USING THE WBS
Deployed/working position: Faceshield lowered in front of the wearer's face, secured in place with a click sound.
Stowed position: The faceshield is balanced over the helmet's crown. Position the faceshield upright to allow the WBS to
move to the stowed position. Ensure WBS arm is positioned upright before turning the faceshield. Secure the helmet with
click sound. (Optional: The faceshield can be gently pressed towards the helmet shell to reduce profile further.)
Practice operating the faceshield and WBS before entering the hazard area. The system is designed to be lifted and
lowered using one hand to grip the chinguard.
HELMET
WBS Working position
It is recommended to keep the faceshield and WBS attached to the helmet. Repeated mounting and removal of the WBS
and faceshield can damage the helmet attachment slots and prevent proper fitting.
To remove the faceshield, reverse the mounting process above.
helmet
®
WBS 2 release positions (Watch the marks on Cover and Arm )
HELMET
WBS Working position
HELMET
WBS Stowed position
8