Sony XDCAM PDBK-202 Bedienungsanleitung Seite 11

System Configuration
Examples
The following figures show examples of systems.
Examples of i.LINK TS input/output usage
(PDW-HR1 only)
a)
a)
a) a)
HDV recorder
a) i.LINK TS
Note
Before connecting an HDV camcorder or an HDV recorder
by an i.LINK cable, set up the camcorder or recorder to
input/output HDV signals via the i.LINK interface.
For details about i.LINK interface settings, refer to the
Operating Instructions for the HDV camcorder or HDV
recorder.
PDW-HR1 (with this board
installed)
HDV camcorder
HDV compatible
nonlinear editing
system
Examples of DVB-ASI input/output usage
When the target device is the PDW-HR1
PDW-HR1 (with this board installed)
a)
Receiver
Distribution system
a) DVB-ASI
When the target device is an XDS Series device
XDS Series device (with this board
installed)
a)
Receiver
Distribution system
a) DVB-ASI
To input DVB-ASI TS signals
Use the DVB-ASI TS signal input connector on the target
device (see the previous figure).
PDW-HR1: SD/HDSDI INPUT connector
XDS Series device: HD/SD-SDI INPUT connector
Supported DVB-ASI TS input signals (PDW-HR1
only)
Support is limited to DVB-ASI TS signals output by
optional XDCAM devices (such as the HDCA-702) that
support MPEG-2 transport stream transmission.
Menu settings
Set the following items.
a)
Modulator
Distribution system
a)
Modulator
Distribution system
System Configuration Examples
11