Sony XDCAM PDBK-202 Bedienungsanleitung Seite 10

Overview
The PDBK-202 MPEG TS Board (called "this board" in
the following) is an option board for installation in the
Sony PDW-HR1 Professional Disc Field Station or XDS
Series Professional Media Station.
The principal features of this board are as follows.
When this board is installed in the PDW-HR1, you can
1)
input MPEG TS signals (IEEE 1394 compliant, interlace
or progressive scan) compatible with the HDV
format, and record these signals on XDCAM Professional
Disc.
You can also play back XDCAM Professional Disc and
output MPEG TS signals (IEEE 1394 compliant, interlace
or progressive scan) compatible with the HDV 1080i
format and DVB-ASI TS signals.
Installing this board in an XDS Series device allows DVB-
ASI TS signals to be input to / output from the device.
Note
XDS Series devices do not support i.LINK.
1) MPEG TS: MPEG-2 transport streams containing MPEG video, MPEG
audio, and control information. This is the standard interface for HDV
equipment.
2) HDV and are trademarks of Sony Corporation and Victor
Company of Japan, Limited.
3) HDV 1080i: Refers to devices compliant with the "HDV 1080i Standard"
for recording HD signals on DV tape. Supports HDV 1080/59.94i or 1080/
29.97P and HDV 1080/50i or 1080/25P.
About operating instructions
Refer to the Operation Manual for the device in which you
install this board (called "the target device" in the
following).
PDW-HR1: 1st Edition
XDS-1000: 1st Edition (Revised 1)
XDS-PD1000/PD2000: 1st Edition
The following is supplementary information to be added to
the above manual when this board has been installed in the
PDW-HR1 or XDS series device.
When the target device is the PDW-HR1
Notes
• This board cannot record DV signals.
• i.LINK (TS) is not output when the video format is 720P.
• If, after editing material with a nonlinear editor
connected to the PDW-HR1, you want to write the
material back to a PDW-HR1 disc, then set F2: PB/EE
on the HOME page of the function menu to "EE".
• To upload materials from the PDW-HR1 to a nonlinear
editor, set F2: PB/EE on the HOME page of the function
menu to "PB".
10
Overview
Checking software versions
Check to be sure that the software version of the PDW-
HR1 is 2.0 or higher and that the software version of the
XDS Series device is 1.1 or higher.
You can check the software versions with maintenance
menu item M30: SOFTWARE VERSION. For details, refer
to "Maintenance Menu" in the target device Operation
Manual.
If the software versions of this board and the
target device do not match
2) 3)
When you power on the target device immediately after
1080i
installing this board, the error code "ERROR 95-119" or
"ERROR 95-419" may appear. This is not a malfunction.
Carry out the procedure for updating the target device to
the latest version of the software package with this board
installed in the device.
This updates both the target device and this board.
For more information about updating the software,
contact your Sony dealer or a Sony service representative.