Werbung
Verfügbare Sprachen
Verfügbare Sprachen
RECORDING
NOTE ON CASSETTE INSERTION
NOTES ON OPERATION
Before inserting a cassette, take up any slack in the tape to prevent it
@When
the POWER
switch is depressed, the
!
button's indicator
from becoming tangled around the capstan.
will flicker for about 4 seconds. While the indicator is flickering, the
cassette deck function buttons do not operate.
@ The cassette deck function buttons cannot be activated if there is
no cassette in the cassette holder.
RECORDING PROCEDURE
Follow the numbered sequence.
The indicator corresponding
to the type of tape inserted lights.
with the tape surface
down.
Se
—
Poooay
TYPE 1
TYPE
II
TYPE
IV
TT
SG
Select the desired program
source and play the program.
ISS switch
For recording with the Dolby NR process,
?oooa~
DOLBY NR
DOLBY NR
Press the
®
and @ buttons at the same time.
Recording will begin.
[oy
Do ie
~ OD
For recording without the Dolby NR process,
press to release the switch ( (7 OFF).
@No recording level adjustment is necessary with the Sony new
ISS (Interference suppress switch)
automatic recording system. *?
If interference is encountered while recording MW or LW programs,
The recording
level is not affected
by the VOLUME,
TONE,
or
use the ISS switch on the bottom to suppress the interference. Slide
BALANCE
control, so you can listen to the program at any volume
the switch to 1, 2 or 3 position, depending on which best reduces the
and with any tone adjustments you want while recording.
noise.
;
i
@The type of tape to be used is automatically detected by the
automatic tape selector system. *?!
@To stop the recording, press the Ml button.
At the end of the tape, the tape stops and the pressed buttons are
automatically disengaged.
10
Werbung
