Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8. Push the lower blade between the loosened fixing
screws (7).
9. Position the lower blade so that the grinding
surface protrudes approx. 1.5 to 2 mm beyond the
edge of the upper blade (fig. 5).
10. Tighten the fixing screws (7) using the tool.
8
CLEANING
WARNING AGAINST ELECTRICAL VOLTAGES
Keep the device away from water or other liquids, otherwise an electric shock or
short circuit may result.
CAUTION
Keep your fingers away from the sharp edges of the blades to avoid injury.
NOTICE
Do not use aggressive solvents/cleaning agents, brushes, sharp objects or similar
for cleaning. These can damage the surface.
After each use, remove oil and hair from the clipper with a dry cloth and the cleaning
brush. Finally, oil the blades as described in section 7.3.
Also clean the head and the air filter regularly.
8.1
CLEANING THE CLIPPER HEAD
Clean the clipper head regularly. The cleaning cycle depends on the frequency of use.
Clean the head as soon as the blades are changed at the latest.
CAUTION
Keep your fingers away from the sharp edges of the blades to avoid injury.
1. Switch off the clipper and disconnect the clipper from the power supply.
2. Remove the blades as described in section 7.4.
The inside of the clipper head is exposed.
3. Clean the inside of the head and the blades thoroughly with the cleaning brush.
4. After cleaning, reinstall and oil the blades as described in section 7.4.
22
INSTRUCTION MANUAL VOSS.FARMING PROFICUT
approx. 1,5
to 2 mm
Fig. 5
85305 - 07.2021 - V2
Werbung
