EuroLite LED Strip 240 5m 5050 RGB 24V Bedienungsanleitung Seite 11

OPERATION:
The Controller has several buttons with following functions:
PT: Press to change modes (M1 – M4).
PAUSE: Press once to hold the current color, press again to continue color change
BRT +: Increasing brightness. Default is the brightest level.
- : Decreasing brightness.
SPD +: Increasing speed. Default is the fastest level.
- : Decreasing speed.
ON/OFF: Press once to turn on, press again to turn off.
Mode
M1 Seven color flash
M2
M3
M4
Please note: Never run the LED Strip 240 5m 5050 RGB 24V in the packaging or rolled up!
Note: * This controller can be supplied with both 12V as well as 24V.
* If the input voltage is 12 V, then the controller transmits 12V as well.
* Please ensure, that LED Strips with a voltage of 12V or 24V only are connected to this
RGB controller.
* Please do not connect LED Strips of differing voltages.
CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the device. Please use a moist, lint-free cloth. Never use alcohol or
solvents!
There are no serviceable parts inside the device. If defective, please dispose of the unusable LED Strip 240
5m 5050 RGB 24V in accordance with the current legal regulations.
Should you have further questions, please contact your dealer.
Description
Partial fade
Full fade
Loop
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
11/12 00051880 Version 1.6