Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Problem
Water flows inside the refrigera‐
tor.
Water flows on the floor.
The temperature in the appliance
is too low/too high.
If the advice does not lead to the
desired result, call the nearest Authorized
Service Centre.
8.2 Replacing the lamp
The appliance is equipped with a
long-life LED interior light.
It is strongly recommended to use
original spare parts only.
Use LED bulbs (E14 base) only. The
maximum power is shown on the lamp
unit.
Possible cause
Food products prevent the water
from flowing into the water collec‐
tor.
The water outlet is clogged.
The melting water outlet is not
connected to the evaporative tray
above the compressor.
The temperature is not set cor‐
rectly.
The door is not closed correctly.
The food products' temperature is
too high.
Many food products are stored at
the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened often.
There is no cold air circulation in
the appliance.
CAUTION!
Disconnect the plug from the mains
socket.
1. Pull the left side of the lamp cover with
your fingers to unlock it. Remove the
cover by pulling it towards yourself.
Solution
Make sure that food products do
not touch the rear plate.
Clean the water outlet.
Attach the melting water outlet to
the evaporative tray.
Set a higher/lower temperature.
Refer to "Closing the door" sec‐
tion.
Let the food products tempera‐
ture decrease to room tempera‐
ture before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessary.
Make sure that there is cold air
circulation in the appliance. Refer
to "Hints and tips" chapter.
1
2
1
ENGLISH
15
Werbung
